Anats S.A. Logo

HOT WATER BOTTLE LΑΤΕΧ FRΕΕ, WITH COVER COLORED WITH BABY ART

Hot Water Bottle Latex Free, With Cover Colored With Baby Art
Manufacturer: FORMESA
SKU: 168-16-022

HOT WATER BOTTLE WITH COVER

• This water heater is designed for partial filling.

• Do not fill the boiler with boiling water. Fill up to a maximum of two-thirds capacity or less. Do not overfill as this could cause cracks in the hot water. Keep the warmth from the neck in an upright position and fill slowly to avoid splashing hot water. Remove the air by carefully lowering it to a flat surface until the water appears at the opening. Screw the cap tightly enough, in practice hand tightening should be sufficient. Finally, make sure the hopper is empty.

• Suitable for prolonged contact with skin,

• Under no circumstances should the paddle be used as a cushion and sit on it.

• Do not fill it with water from the water heater, as this can significantly reduce the lifetime of the water heater.

• Avoid contact with hot surfaces.

• Avoid contact with oil or grease.

• When not in use, drain it completely and store it without the cap in a dry, cool, shady place. Avoid exposure to sunlight.

• Do not place anything on the hot water during storage.

• Check the heaters and cap for damage and damage before use.

• Hold the hot water from the neck and upside down on the sink, away from your body and press lightly to check for leaks.

• Do not heat the stove in the oven or in the microwave oven.

• Replace the water heater immediately if it appears damaged or damaged, has cracks, is brittle or sticky